![]() ![]() It is hard to describe all the functions so here is a small video demonstrating the NMX Controller integration and the new Interval Controller After the channel is dropped the operator dialog will be shown where the operator parameters can be changed(duration, easing, end value). Operators can be added by dragging the channel from the channels list (3) to the interval graph area (4). Currently the ‘Interval’ and ‘NMX Motor’ channels support operator. DSLR – this channel support the ‘Perform capture’ option (if enabled the capture command will be sent to this DSLR) and the ‘Capture finished notification’ (if enabled this DSLR capture finished notification will be used for motor movement).Ĭhannels also support operators that will change the channel value over defined time with an applied easing.NMX motor – the motor starting position can be changed.interval – the starting interval can be changed.The following channel parameters are currently available: ![]() After the channel is added to the interval controller graph it name will be listed under ‘Channels’ (3)īy clicking on the registered channel name (3) the user can change the channel parameters if it supports it. The user can add the channel to the interval controller graph (4) by simply dragging the channel name to the interval controller graph (4) and dropping there. DSLR – these are the channels for the connected DSLRs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |